Fire Safety Products

• Provides illumination of exit routes during an emergency
• Specifically designed for floors
• Adheres tp BS5499-1:2002
• Used in factories, shops, schools, hospitals, pubs and clubs
• Easy to apply
• Guaranteed illumination in total darkness (glow-in-the dark)
• Can be applied by brush, roller, or spray system
• Two part paint system (base, photoluminescent)
• Available in a pack with both components or as individual coats

Fire Escape Floor Marking Discs compliment any existing wayguidance systems. The self adhesive backed discs are easy to install and give further enfisise on the escape route. 

• Self adhesive backed discs
• Suitable for concrete and vinyl flooring
• Compliments existing wayguidance systems
• Adheres tp BS5499-1:2002
• Pack of 10 discs
• JALITE AAA material stays brighter for longer than P.S.P.A. Class A materials: expect 3-4 times the luminance performance

The priority in an emergency situation, requiring evacuation, is to enable occupants to leave the building quickly and safely. It is therefore important that escape routes and any obstacles or changes in level along these routes are highlighted. 
Photoluminescent tapes provide a cost-effective way of identifying obstacles, dangerous locations and traffic routes. Jalite tapes can be seen in darkness (glow-in-the dark) and provide visible escape route illumination.

• There are three tape designs available:
  • Plain vinyl tape
    • Hi-light skirting/hand rail, general illumination of stairway and escape route
  • Striped vinyl tape
    • Green: safe condition, zone marking, door and emergency escape identification
    • Red: hi-light fire fighting equipment and obstacle marking
    • Black: danger zone marking, hi-light unsafe exits and hazard identification
  • Arrowed vinyl tape
    • Hi-light directional route marking, skirting/hand rail and use for way-finding identification
    • Available with man only, man and 'exit' text or man and 'fire exit' text
    • Each roll comes plain, with transparent stick-on left and right direction signs
• All are available with a width of 40mm or 80mm
• Adheres tp BS5499-1:2002
• All are available in 10m lengths, the plain and striped versions are also available in 5m lengths

Under conditions of total power failure JALITE Photoline Stair-nosing will immediately illuminate (glow-in-the dark) stairs to help the evacuee on the way out of a building.

Stair-nosing has been designed to complement existing emergency systems. Local or emergency power failure on stairways could be a fatal hazard for evacuees. Under conditions of total power failure, JALITE Photoline Stair-nosing will immediately illuminate the edges of steps to help the evacuee to orientate, locate stair edges and risers, and assist in the safe evacuation of the premises.

Stair-nosing requires no electrical connection, is simple to install and requires no special maintenance other than that which you would normally carry out on any similar product.  Only normal illumination, daylight, fluorescent or standard tungsten filament required to activate its performance.

• Each pack of stair-nosing contains 15 x 1.375m lengths
• Suitable for 2-3.5mm gauge floor coverings
• Available straight-back or raked-back stairnosing
• JALITE AAA material stays brighter for longer than P.S.P.A. Class A materials
• Simple to install
• Adheres tp BS5499-1:2002
• No electrical connection required

• Provides illumination of exit routes during an emergency
• Use on floors, ceilings, doors and walls
• Suitable for steel railings
• Used in offices, factories, shops, schools, hospitals, pubs and clubs
• Easy to apply
• Guaranteed illumination in total darkness (glow-in-the dark)
• Can be applied by brush, roller, or spray system
• Water-based three part paint system (base, photoluminescent and protective)
• Available in a pack with all three components or individual coats